ここから本文です
TWO:5. The lubrication of surfaces working under air pressure, such as the pistons and valves of engines.CHAPTER LIX. LIGHT IN THE CORNER HOUSE.
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:I had a short chat with the wounded men near the various houses, on demand showed my passport to those in authority, and was advised as a friendly Netherlander to return, as it was extremely dangerous on the road. But I did not dream of doing34 this, as long as I was not compelled, and went on towards Lige amidst this maddening thunder.Very slowly the huge monster sauntered along, stopping and waiting everywhere to allow long trains with fresh troops to pass. These came straight from Germany, with the youngest levies and volunteers who had just finished their drill. These had decorated their trains all over with green boughs and outside painted all sorts of caricatures, from which especially King George had to suffer much. Then one read "To Paris, to England," and similar hopeful devices.

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:A little farther on a few houses were left undamaged, because they stood outside the town proper. A woman who had remained in her house stood outside with cigar-boxes under her arm. She offered cigars from an open box to the soldiers of the passing divisions. To me she seemed to be out of her mind, as she stood there trembling, her face distorted from hypernervousness. Her cringing kindness was of no avail, for I noticed a couple of days afterwards that her house too had been totally destroyed.

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:"The Burgomaster."The general expatiated once more on the francs-tireurs of Louvain, and asked me to explain in my papers without fail that the citizens had to thank themselves for what had happened. The sergeant who had taken me to him was ordered to escort me, that I might not have any further trouble with the soldiers in the city.
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.